Air in system following upgrade
Plumbing
•
356 views
•
1 answer
I have a big problem with air in the system. So far, four plumbers have failed to identify the cause, but each one visited once only and then "became unavailable". New oil boiler/cylinder/pump/controls were installed 6/7 months ago and the central heating and hot water is really good except for …
Shower that runs from combi boiler
Plumbing
•
354 views
•
1 answer
I have a shower that runs from my combi boiler. When the shower is turned on it is hot then make a clicking noise and goes ice cold then goes hot again. This happens every minute of less. I had a plumber round who fitted a new shower and it's …
Shower
Plumbing
•
351 views
•
9 answers
I have had a shower put in it was pooling he’s now put another in but it’s not draining he said it’s cause it’s a concrete shower tray I said it’s plastic he said it’s not so I assume it’s resin . Should I expect water left in tray
Help! Potential soil stack issue
Plumbing
•
350 views
•
3 answers
I live in a block of flats and the flat above me is having an issue in their on suite bathroom with heat potentially rising up through the soil stack which is causing water damage to their flat and their mains drainage pipes are extremely hot to the point of …
Cause of pressurised hot tank drip?
Plumbing
•
350 views
•
1 answer
Hi I have a pressurised oil fired heating system. Range hot water storage tank. I have an intermittent drip from the drain pipe - after water inlet control valve (3.5 bar) and pressure release valve (6 bar). Looking advice on cause - is it the PRV or the inlet control …
What's required to attach this 2-Hole Basin Mixer Tap Wall?
Plumbing
•
348 views
•
1 answer
Hi All, my plumber is stumped on how this https://www.heatandplumb.com/acatalog/signature-tiber-tap-dits1176 attaches to the wall, please can anyone suggest parts that will help?
Thermostatic bar mixer shower
Plumbing
•
347 views
•
3 answers
Hi, I'm thinking of changing from a electric shower to a thermostatic mixer fed by a combi vaillant eco tec pro 28 boiler I think it's optimum running rate is around 1bar, the boiler is in the bathroom and about 1.5mtrs from where the shower will be, my query is …
Accessing thermostatic valve housing
Plumbing
•
346 views
•
2 answers
I have removed the cover of my concealed shower valve. It's a hudsun Reed I think. I have removed the grub screw but nothing else seems to move. i don't know what to do next. Have photos.
Bath shower mixer tap
Plumbing
•
346 views
•
1 answer
Hi, I want to install a shower mixer tap to my bath (currently single taps) and want to know if this is possible as I have a water tank (on the same floor as the bathroom) but also have a boiler which controls the temperature, I think. Will installing a …
Mini dishwasher
Plumbing
•
346 views
•
1 answer
I ordered the Cookology mini dishwasher. Can you please tell me which adapters I need to plumb into the cold water tap. The tap is stainless steel square with a rubber round at the bottom of the tap. I can send you some photos of the tap. I’ve been searching …