Bathroom Fitting Questions

Cost of Replacement Shower Enclosure and Tray?
Bathroom Fitting  •  659 views  •  1 answer

Looking for average cost of replacing a square shower enclosure and tray with small amount of tiling and updating of waste area thanks

Fitting separate hot water supply
Bathroom Fitting  •  644 views  •  2 answers

Have put 2 ensuites upstairs but water from combi not capable of running them at the same time as others downstairs would like a solution to running a separate hot water supply via electric to supply bath 2hand basins and mixer shower many thanks pete

Shower door rattles when closing
Bathroom Fitting  •  630 views  •  2 answers

I've had a new shower, tray and door put in but the sliding door is not soft close and rattles when it hits the frame when closing it. Is there anything I can do to make it soft close? Thanks

Shower rollers
Bathroom Fitting  •  596 views  •  2 answers

Bottom rollers are discontinued can I use anything else to secure the doors .Spring rollers no hole in door to attach

Smart Pan for bath install?
Bathroom Fitting  •  588 views  •  0 answers

Bought Affine Fontaine against the wall free standing bath. Install sheet has a Smart Pan listed. It’s a clever piece of kit but nobody in uk has one Searches online only bring up loos! Strangely Reece in Australia plumbing supplies pops up and they have one Does anyone know where …

Shower cubicle
Bathroom Fitting  •  535 views  •  1 answer

I need a new shower cubicle 1200 x 900 but whoever fitted the shower tray has reset it into both walls so a little bit smaller than the above measurements, so will a 1200 x 900 cubicle be ok and be adjusted? live in Merseyside thank you

Electric shower
Bathroom Fitting  •  513 views  •  3 answers

I need to replace an electric shower who do I need plumber or electrician. Can I do it myself?

Why is new tap dripping?
Bathroom Fitting  •  503 views  •  1 answer

Hi , had a dipping tap on the hot tap in the downstairs bathroom so just decided to get a new set, put them on and the hot tap is still dripping, I did have a new boiler fitted over a month ago could the pressure be to much for …

Wall Hung Toilet Frame Compromised?
Bathroom Fitting  •  502 views  •  1 answer

My plumber has ordered and fitted a wall hung tailet frame. However, in order to get it to fit he has sawn off a horizontal bar at the top of the frame where the brackets to attach the frame to the wall were located. The effect is now the frame …

Toilet flushing
Bathroom Fitting  •  453 views  •  5 answers

Help! My toilet stopped flushing, I searched the net, found the problem was probably a worn flapper. I bought the full kit, a Dudley 88, which was the same model as in the tank. I fitted it, fairly straightforward, but it refuses to dump the water, just trickels the water …